Hi, I downloaded and installed the QNX RTP from Tucows, (The one which runs
off of a FAT partition, qnxrtp.exe), Install went fine, picked up my gateway
and other network config. After rebooting everything works fine until I
receive a message about Packages not being able to opened. I have rerun
several times with the boot options for shell only and verbose and it mounts
the filesystems (base and root) fine.
P120
32MB RAM
2MB S3 Video Card (Diamond Stealth)
NE2000 compatible network card
Any suggestions?
I have downloaded it again but still no joy…
I had the same when I installed QNX on disk D. Then I reinstalled it on disk
C and all became fine.
GlebM.
Paul Priest <pjp104@york.ac.uk> wrote in message
news:8qsuor$h19$1@pump1.york.ac.uk…
Hi, I downloaded and installed the QNX RTP from Tucows, (The one which
runs
off of a FAT partition, qnxrtp.exe), Install went fine, picked up my
gateway
and other network config. After rebooting everything works fine until I
receive a message about Packages not being able to opened. I have rerun
several times with the boot options for shell only and verbose and it
mounts
the filesystems (base and root) fine.
P120
32MB RAM
2MB S3 Video Card (Diamond Stealth)
NE2000 compatible network card
Any suggestions?
I have downloaded it again but still no joy…