Finally someone who noticed my cry for help 
Ok ipstats was empty and the
out put of nicinfo was:
3COM (90x) 10BASE-T (TPO) Ethernet Controller
Physical Node ID … 000208 666BB8
Current Physical Node ID … 000208 666BB8
Media Rate … 10.00 Mb/s half-duplex UTP
MTU … 1514
Lan … 0
I/O Port Range … 0xE400 → 0xE43F
Hardware Interrupt … 0xB
Total Packets Txd OK … 3
Total Packets Txd Bad … 0
Total Packets Rxd OK … 1
Total Rx Errors … 0
Tx Collision Errors … 0
Tx Collisions Errors (aborted) … 0
Carrier Sense Lost on Tx … 0
FIFO Underruns During Tx … 0
Tx defered … 0
Out of Window Collisions … 0
FIFO Overruns During Rx … 0
Alignment errors … 0
CRC errors … 0
Frostie
“Mario Charest” <mcz@videotron.ca> wrote in message
news:8qvpvt$8tj$1@inn.qnx.com…
It is possible although your card was detect that it isn’t
working problem (problem with auto detect of the media type)
Post the output of “nicinfo” and the ouput of “cat /proc/ipstats”
“Frostie” <> frustie@dds.nl> > wrote in message
news:8quui1$78i$> 1@dinkel.civ.utwente.nl> …
Hi,
since I am a newbee to qnx i can’t figure out what is wrong with the
dhcp.
When using windows it detects everything and it works right away. With
qnx
however (dl’ed latest version last night) it doesn’t do anything. My
3com905b 10/100 ethernetadapter is support and when I check if it was
detected (in photon) it had dhcp turned on but nothing happened. I tried
my
mac adress as my user id but that was of no help either. Does anyone
know
what this problem can be? and better yet how solve it > 
TIA,
Frostie
\