Hi,
booting from Dos or Disk A: or from Cd allways gives the same result.
QNX does not boot on my sysi-only PC though the Dawi 2976 Controller
with NCR-53c875 ist supported.
Qnx tryes to detect IDE and offcourse does not find any ide-drives but
the scsi-controller is not listed too.
After that, some files are not found or don’t seem to exist . . and
that’s all.
Do i have to add some parameters during booting to enabel the NCR
support or does qnx need a ide drive to boot from?
If u talk about the latest QNX RTP version, please note that it is
impossible at the moment to install this version onto SCSI disk… (as
written in the FAQ at qnx.com). They also say that version following (in the
future) the QNX RTP Prerelease will be able to be installed onto SCSI HD.
Hi,
booting from Dos or Disk A: or from Cd allways gives the same result.
QNX does not boot on my sysi-only PC though the Dawi 2976 Controller
with NCR-53c875 ist supported.
Qnx tryes to detect IDE and offcourse does not find any ide-drives but
the scsi-controller is not listed too.
After that, some files are not found or don’t seem to exist . . and
that’s all.
Do i have to add some parameters during booting to enabel the NCR
support or does qnx need a ide drive to boot from?