Hey i’m a QNX newbie and i have the latest version of the OS, and the
problem i’m having is when i go to browse the internet with my cable modem
it dont work, i’ve tried everything and it still just dont wanna work. The
NIC isn’t supported(Its a LinkSys LNE100TX), but it transfers data through
the line. I just wanna know how to make this work. Any help will be greatly
appreciated.
Previously, Jeff Raines wrote in comp.os.qnx:
Hey i’m a QNX newbie and i have the latest version of the OS, and the
problem i’m having is when i go to browse the internet with my cable modem
it dont work, i’ve tried everything and it still just dont wanna work. The
NIC isn’t supported(Its a LinkSys LNE100TX), but it transfers data through
the line. I just wanna know how to make this work. Any help will be greatly
appreciated.
You are being a little unspecific about what your problem is. The LinkSys
card came in a few different variants, and not all originally worked.
I’m not sure what the latest news is, but it is quite possible the
driver is working ok. You don’t indicate how you know this, so it’s
hard to tell.
Can you ping your router’s IP? If so then you may just have
to do some simple configuration. Are you using the tiny
stack or the full stack. In either case you must have your
own IP setup either by fixed IP or using DHCP. If not using
DHCP you will also need to manually setup your gateway and
name servers.
Mitchell Schoenbrun --------- maschoen@pobox.com