TCP/IP - QNX6

QNX Newsgroups (Archives) comp.os.qnx
1

Hi All,

I’ve just started using QNX6, and I have some
difficulties finding proper setup files (a bit
different than QNX4, and there is no complete
sys admin guide for new users). I would like
to use QNX6 PC as a router in configuration
like this:

±----+
| PC1 | TCP/IP, WinNT
±----+
|
| (modem and/or direct serial line)
|
±----+
| PC2 | TCP/IP, QNX6
±----+

±----+ ±----+ ±----+
|PLC1 | |PLC2 | |PLC3 |
±----+ ±----+ ±----+
(all Programmable Logic Controllers have built-in
TCP/IP interface with ability to specify gateway’s
IP address).

Where do I specify IP forwarding and other settings
needed for PC2 to act as a router?

Thanks,
Zeljko

2

try to apply the parameter “forward” at npm-tcpip.so - see help for QNX 6

io-net … -ptcpip tcpip_options

Good luck
Jörg

Zeljko Fucek <zfucek@arpeco.com> schrieb in im Newsbeitrag:
9r6d3u$qv6$1@inn.qnx.com…

Hi All,

I’ve just started using QNX6, and I have some
difficulties finding proper setup files (a bit
different than QNX4, and there is no complete
sys admin guide for new users). I would like
to use QNX6 PC as a router in configuration
like this:

±----+
| PC1 | TCP/IP, WinNT
±----+
|
| (modem and/or direct serial line)
|
±----+
| PC2 | TCP/IP, QNX6
±----+

±----+ ±----+ ±----+
|PLC1 | |PLC2 | |PLC3 |
±----+ ±----+ ±----+
(all Programmable Logic Controllers have built-in
TCP/IP interface with ability to specify gateway’s
IP address).

Where do I specify IP forwarding and other settings
needed for PC2 to act as a router?

Thanks,
Zeljko