Hello, I contact you because I have a problem with a 6Go Hard disk.
Problem:
When I install QNX 4.24, and when I reboot my computer, the system stop on
the line :
“Press Esc for alternate OS…C”,
or after the line:
“Press Esc for alternatre OS…”.
I was installed QNX on several computer on this disk, and it’s the same
problem.
Perhaps, my Hard disk has a problem, but under DOS, it was running normaly.
CHANAUD <lc@bcisa.com> wrote:
Hello, I contact you because I have a problem with a 6Go Hard disk.
Problem:
When I install QNX 4.24, and when I reboot my computer, the system stop on
the line :
“Press Esc for alternate OS…C”,
or after the line:
“Press Esc for alternatre OS…”.
I was installed QNX on several computer on this disk, and it’s the same
problem.
The …C means that the boot loader is passed the 1024 cylinder boundary.
If you look in our knowledgebase (qdn.qnx.com), you will find an article
which describes this problem and how to fix it. Go to:
http://qdn.qnx.com/support/bok/solution.qnx?9456
Perhaps, my Hard disk has a problem, but under DOS, it was running normaly.
I hope you can help me.
Thanks to your help
CHANAUD LAURENT
BCI NAVIGATION
3 Allée des ingénieurs
Parc Actimart
13851 AIX EN PROVENCE CEDEX 03
Tel : 04 42 90 06 37
Fax : 04 42 24 35 30