I’m trying to replace my Dlink (Net.via ) card with one that will
run under both RTP and QNX4. The LNE100TX works fine under rtp,
but Net.tulip dosn’t see it.
RTP’s pci output for the card follows. Can I get this card to run
under qnx4?
Class = Network (Ethernet)
Vendor ID = 1317h, Admtek Inc
Device ID = 985h, Unknown Unknown
PCI index = 0h
Class Codes = 020000h
Revision ID = 11h
Bus number = 0
Device number = 19
Function num = 0
Status Reg = 290h
Command Reg = 117h
Header type = 0h Single-function
BIST = 0h Build-in-self-test not supported
Latency Timer = f0h
Cache Line Size= 8h un-cacheable
IO Address = f800h length 256 enabled
Mem Address = ffbeec00h 32bit length 1024 enabled
CardBus CIS Pointer = 202h
Subsystem Vendor ID = 1317h
Subsystem ID = 574h
Max Lat = 255ns
Min Gnt = 255ns
PCI Int Pin = INT A
Interrupt line = 15
Capabilities Pointer = c0h
Capability ID = 1h
Capabilities = fe02h - 0h
David L. Hawley D.L. Hawley and Associates