Hello, I’m trying to use an analog external modem on /dev/ser1 to dial
in.
Qtalk can communicate and bring the modem to dialin succesfully.
With the application dialer no dialin will succeed, because of wrong
initialization string. If I edit the communcation modem initialization
string using phlip for example from ATZ to ATM1 or anything other, the
terminal shows while the new connect always the old command ATZ again.
Why not the new string? The new string is definitely written in the
dialup configuration textfile.
It seems, the dialer won’t look for that string that is placed there?
Hello, I’m trying to use an analog external modem on /dev/ser1 to dial
in.
Qtalk can communicate and bring the modem to dialin succesfully.
With the application dialer no dialin will succeed, because of wrong
initialization string. If I edit the communcation modem initialization
string using phlip for example from ATZ to ATM1 or anything other, the
terminal shows while the new connect always the old command ATZ again.
Why not the new string? The new string is definitely written in the
dialup configuration textfile.
It seems, the dialer won’t look for that string that is placed there?
When you say phlip, I assume you mean phdial (since this is a QNX4 forum).
If you mean QNX6, then you should post in the apps newsgroup for RTP.
…
That behaviour is strange, because my works correctly. Modifications made
as shown by the terminal window. Perhaps you can post a sin ver - maybe an
update will be in order.
With a PC, I always felt limited by the software available.
On Unix, I am limited only by my knowledge.
–Peter J. Schoenster <pschon@baste.magibox.net>