I have a pair of networked PC’s. I have QNX installed on one of them and
would like to configure it so I can access the other PC via the network.
I use the LinkSys Fast Ethernet 10/100 in a Box (uses the LNE100TX). On the
Windows side, there are “no” IP addresses, no gateways defined, no host
names, etc… Basically, all I had to do was make sure both PC’s were part
of the same workgroup.
What do I need to do so that QNX will have access to the network?
Thanks!
Hi Dale,
You need to assign IP addresses to both machines.
Regards,
Joe
Dale Frameli <dframeli@texas.net> wrote:
I have a pair of networked PC’s. I have QNX installed on one of them and
would like to configure it so I can access the other PC via the network.
I use the LinkSys Fast Ethernet 10/100 in a Box (uses the LNE100TX). On the
Windows side, there are “no” IP addresses, no gateways defined, no host
names, etc… Basically, all I had to do was make sure both PC’s were part
of the same workgroup.
What do I need to do so that QNX will have access to the network?
Thanks!