How can I get my DOC to work?

I’ve installed the QNX6.1 into the harddisk of a 5x86 embeding board,but the
OS can not find my M-SYSTEM DOC 2000 on the board,so I start the devb-doc &
manually,the manager some times report an error of “BUS ERROR” and other
times it exited without any error reporting,in this case,any excutions could
no longer run in the shell(such as ls,cp…),the sh report “can not
fork…,try again”,can somebody help me?
thanks

“Liping Peng” <penglp@hope.com.cn> wrote in message
news:9saqpe$cbk$1@inn.qnx.com

I’ve installed the QNX6.1 into the harddisk of a 5x86 embeding board,but
the
OS can not find my M-SYSTEM DOC 2000 on the board,so I start the devb-doc
&
manually,the manager some times report an error of “BUS ERROR”

I think BUS ERROR means a memory parity error.

times it exited without any error reporting,in this case,any excutions
could
no longer run in the shell(such as ls,cp…),the sh report “can not
fork…,try again”,can somebody help me?

Is it possible the DOC conflicts with some other devices?

thanks

I think your best choice is to upgrade your devb-doc driver,there is a new
beta version for Neutrino provided by the m-sys.you can go to the
www.m-sys.com and contact them for one.perhaps this will do you help.
good luck
ChaoLi

“Mario Charest” <mcharest@clipzinformatic.com> wrote in message
news:9sbc5v$mob$1@inn.qnx.com

“Liping Peng” <> penglp@hope.com.cn> > wrote in message
news:9saqpe$cbk$> 1@inn.qnx.com> …
I’ve installed the QNX6.1 into the harddisk of a 5x86 embeding board,but
the
OS can not find my M-SYSTEM DOC 2000 on the board,so I start the
devb-doc
&
manually,the manager some times report an error of “BUS ERROR”

I think BUS ERROR means a memory parity error.


times it exited without any error reporting,in this case,any excutions
could
no longer run in the shell(such as ls,cp…),the sh report “can not
fork…,try again”,can somebody help me?

Is it possible the DOC conflicts with some other devices?

thanks

\