Best 33k6 isa modem / Soundblaster 64 PCI problems..... (rea

QNX Newsgroups (Archives) qdn.public.qnxrtp.installation
1

Hya,

I’m a new user and i have two irritating problems…

  1. Qnx doesn’t seem to see my modem (it worked perfectly in the DEMO).

I’ve already tried:
slay devc-ser8250
devc-ser8250 -u1 2e8, -u2 3e8,7 & (i think the first
is my com -port adress…i used it because my modem is on COM4)

When i used Qtalk -m /dev/ser1 afteward and gave the ATZ command Qtalk
responded with OK, but when i try to connect to my ISP the dialer can’t use
my modem…

I think it might be an IRQ / Port problem… How can i find out what the
adresses are???


2. I have a soundblaster 64 PCI and i just doesn’t work… How can i get it
to work???

Any Ideas???


Thanx in advance :slight_smile:

J

2

I do not how to assist as I am VERY new to QNX, but I did notice the
demo was
QNX 4 while the cd image I downloaded was QNX RTP.

3

Hi


J <jhofman@bart.nl> wrote:

Hya,

I’m a new user and i have two irritating problems…

  1. Qnx doesn’t seem to see my modem (it worked perfectly in the DEMO).

I’ve already tried:
slay devc-ser8250
devc-ser8250 -u1 2e8, -u2 3e8,7 & (i think the first
is my com -port adress…i used it because my modem is on COM4)

When i used Qtalk -m /dev/ser1 afteward and gave the ATZ command Qtalk
responded with OK, but when i try to connect to my ISP the dialer can’t use
my modem…

I think it might be an IRQ / Port problem… How can i find out what the
adresses are???

It’s ISA, unless the card is set to plug and play you should know what the
IRQ’s are (hardwired). Check the bios and make sure that those IRQ’s are not
set to be plug and play as well.

If the modem is set to pnp

http://support.qnx.com/support/bok/solution.qnx?10252


  1. I have a soundblaster 64 PCI and i just doesn’t work… How can i get it
    to work???

Can you post the output from pci -vvv

Thanks

Erick.


Any Ideas???



Thanx in advance > :slight_smile:

J