Hi,
I just got QNX. I installed it into a windows partition. Went fine. I
rebooted. Now, when I select QNX from the menu, it just keeps blinking
the cursor at me, as if it’s loading something. There is no HDD activity
orr anything like that (that I can see) of any kind.
TIA
BW
In addition,
When I try and boot QNX with the boot disk, it loads into the Neutrino
Inside! bit, then it loads the EIDE devices bit e.t.c. but then it says
/.diskroot not found on any filesystems
Entering in safe mode (or something like that)
Cannot find [/packages/…] (forgotton the rest)
PLEASE HELP!!!
BW
In article <MPG.14ca71a6adeee09b989680@inn.qnx.com>, user@domain.tld
says…
Hi,
I just got QNX. I installed it into a windows partition. Went fine. I
rebooted. Now, when I select QNX from the menu, it just keeps blinking
the cursor at me, as if it’s loading something. There is no HDD activity
orr anything like that (that I can see) of any kind.TIA
BW
Previously, BWgames wrote in qdn.public.qnxrtp.installation:
In addition,
When I try and boot QNX with the boot disk, it loads into the Neutrino
Inside! bit, then it loads the EIDE devices bit e.t.c. but then it says
/.diskroot not found on any filesystems
Entering in safe mode (or something like that)
Cannot find [/packages/…] (forgotton the rest)PLEASE HELP!!!
BW
In article <> MPG.14ca71a6adeee09b989680@inn.qnx.com> >, > user@domain.tld
says…
Hi,
I just got QNX. I installed it into a windows partition. Went fine. I
rebooted. Now, when I select QNX from the menu, it just keeps blinking
the cursor at me, as if it’s loading something. There is no HDD activity
orr anything like that (that I can see) of any kind.TIA
BW
\
What harddrive / Harddisk controller do you use?
SCSI / Ata 66/100 are not yet supported.
booting from SCSI will be supported in patch A that will be released in a few days (tomorow..?)