AMD 79C790A

Has anybody out there had any luck with getting any other
than “Initialisation Error 10 Initialisation Error 4” when trying to start
Net.ether2001 with this chip set. ?

I have QNX version 4.22 - There does not seem to be anywhere to
find its IO address - I have tried starting Net.ether2001 with the interrupt
parameter but still no joy ???

Bob

Previously, Bob miles wrote in qdn.public.qnxrtp.installation:

Has anybody out there had any luck with getting any other
than “Initialisation Error 10 Initialisation Error 4” when trying to start
Net.ether2001 with this chip set. ?

I have QNX version 4.22 - There does not seem to be anywhere to
find its IO address - I have tried starting Net.ether2001 with the interrupt
parameter but still no joy ???

First of all, this is the wrong conference for QNX4 related questions. They
should be under the qdn.public.qnx4 conference. Secondly, I guess you are
talking about the Net.ether2100 driver. Have you tried passing both the
port and the irq to the driver? Try ‘use Net.ether2100’.

Hugh.

Bob

\