Hi!
Is it possible to install the 6.1.0 CD-ROM on a single machine without
any other OS installed (-> 1 big partition)?
I intent so, but it returns me the message:
“No QNX 6.1.0 or greater filesystem found…”
after EIDE and SCSI check.
Thanx a lot.
Steve
Hi Steve,
Yup, just boot up from the QNX CD and it will start the installer
for you.
Erick.
Stephan Bergmann <sb@ows.es> wrote:
Hi!
Is it possible to install the 6.1.0 CD-ROM on a single machine without
any other OS installed (-> 1 big partition)?I intent so, but it returns me the message:
“No QNX 6.1.0 or greater filesystem found…”
after EIDE and SCSI check.Thanx a lot.
Steve
Hi Erick.
I’m sorry, but this doesn’t work. Just receive a message like this:
“No QNX 6.1.0 or greater filesystem found…”
Greetings from Spain
Steve
Hardware Support Account schrieb:
Hi Steve,
Yup, just boot up from the QNX CD and it will start the installer
for you.Erick.
Stephan Bergmann <> sb@ows.es> > wrote:
Hi!Is it possible to install the 6.1.0 CD-ROM on a single machine without
any other OS installed (-> 1 big partition)?I intent so, but it returns me the message:
“No QNX 6.1.0 or greater filesystem found…”
after EIDE and SCSI check.Thanx a lot.
Steve
Hi Steve,
It should work without any problems. Actually you should even be able
run the OS in a ‘test’ mode right from the CD. What is the sequence
of the messages you get when you boot from the CD?
Thanks
Erick.
Stephan Bergmann <sb@ows.es> wrote:
Hi Erick.
I’m sorry, but this doesn’t work. Just receive a message like this:
“No QNX 6.1.0 or greater filesystem found…”Greetings from Spain
SteveHardware Support Account schrieb:
Hi Steve,
Yup, just boot up from the QNX CD and it will start the installer
for you.Erick.
Stephan Bergmann <> sb@ows.es> > wrote:
Hi!Is it possible to install the 6.1.0 CD-ROM on a single machine without
any other OS installed (-> 1 big partition)?I intent so, but it returns me the message:
“No QNX 6.1.0 or greater filesystem found…”
after EIDE and SCSI check.Thanx a lot.
Steve