Hi all.
I have a troubles with qnx 6.1
I have PC-104 computer with AMD ELAN 400 processor and 8mb DRAM.
This system reboots or hands on the Elan SC400 board.
solution http://qdn.qnx.com/support/bok/solution.qnx?9614 is not working
correctly. Some time is work, but some time is not.
In article <9vt0ig$n4f$1@inn.qnx.com>, Artem <dpartemua@atlantis.dp.ua>
writes
Hi all.
I have a troubles with qnx 6.1
I have PC-104 computer with AMD ELAN 400 processor and 8mb DRAM.
This system reboots or hands on the Elan SC400 board.solution > http://qdn.qnx.com/support/bok/solution.qnx?9614 > is not working
correctly. Some time is work, but some time is not.
\
Hi Artem,
I’ve had similar trouble with my Elan-based card.
Devc-con crashed because the keyboard controller wasn’t
properly reset by the BIOS on startup.
We’ve also had an Elan based design here at work
which had flakey keyboards, sometimes they’d work,
sometimes not… probably the same problem…
Someone at QNX sent me a little program to reset the
keyboard controller, would you like me to email you
a copy? You’ll need to build it into a new boot image,
so it gets runs before devc-con.
You might need more RAM as well, mine works OK
with 16 Megs ( but I’ve got the full installation
of Photon on it )
Richard Bebbington
Someone at QNX sent me a little program to reset the
keyboard controller, would you like me to email you
a copy? You’ll need to build it into a new boot image,
so it gets runs before devc-con.
Yes of course. Please send me it.