With RTP 6.1 I’m using a Geode GX1 (Advantech with the CS5530A) card and I
have no sound
(impossible to read wav file, only the PC buzzer comes out !)
I’m using "io-audio -dgeode & " => without effect.
For test I follow the Answer from : http://qdn.qnx.com/support/bok/solution.qnx?10435 => without effect.
I try “io-audio -dsb ioport=220,irq=5,dma=1,dma1=1 &” => I have sound but
with a very bad quality.
How can I found the good parameters for the ioport, irq, dma, dma1 ?
With RTP 6.1 I’m using a Geode GX1 (Advantech with the CS5530A) card and I
have no sound
(impossible to read wav file, only the PC buzzer comes out !)
I’m using "io-audio -dgeode & " => without effect.
For test I follow the Answer from : http://qdn.qnx.com/support/bok/solution.qnx?10435 > => without effect.
I try “io-audio -dsb ioport=220,irq=5,dma=1,dma1=1 &” => I have sound but
with a very bad quality.
How can I found the good parameters for the ioport, irq, dma, dma1 ?
Is the card a PCI card? If it is could you do a
‘pci -vvv > pci_out.txt’ and then post the entry for your card from the
pci_out.txt file here.
Regards,
Dave B.
Jeff Hoffmeyer wrote:
Hi all,
With RTP 6.1 I’m using a Geode GX1 (Advantech with the CS5530A) card and I
have no sound
(impossible to read wav file, only the PC buzzer comes out !)
I’m using "io-audio -dgeode & " => without effect.
For test I follow the Answer from : http://qdn.qnx.com/support/bok/solution.qnx?10435 > => without effect.
I try “io-audio -dsb ioport=220,irq=5,dma=1,dma1=1 &” => I have sound but
with a very bad quality.
How can I found the good parameters for the ioport, irq, dma, dma1 ?