A crash has left my .altboot and .boot files at zero length.
I have boot/image/hard.1. Can I recover these two files using
/boot/image/hard.1? and how can I tell my bootsector to load these
files. Lots of trouble in WTV land.
I was just about to send the message below. However, as is typical of my I
wasn’t looking at the newsgroup. If your looking for an RTP boot image then
/boot/images/hard.1 most likely isn’t it. That would be the expected name
of a QNX4 boot image.
Yes, you should be able to. Just cp /boot/images/hard.1 to .boot of your
boot partition. Usually:
cp /boot/images/hard.1 /.boot
A crash has left my .altboot and .boot files at zero length.
I have boot/image/hard.1. Can I recover these two files using
/boot/image/hard.1? and how can I tell my bootsector to load these
files. Lots of trouble in WTV land.
I was able to do the copy like you suggested, but my bootstrap is messed up. I
tried hacking around using the QNX6.0 boot strap and it fired up, but the
process don’t seem to want to run. uname -a shows that the 6.0OS is running not
the 4.25 like I would expect.
Thanks for helping me with my troubles!!!
WTV
“Bill Caroselli (Q-TPS)” wrote:
WAIT A MINUTE!
I was just about to send the message below. However, as is typical of my I
wasn’t looking at the newsgroup. If your looking for an RTP boot image then
/boot/images/hard.1 most likely isn’t it. That would be the expected name
of a QNX4 boot image.
Yes, you should be able to. Just cp /boot/images/hard.1 to .boot of your
boot partition. Usually:
cp /boot/images/hard.1 /.boot
A crash has left my .altboot and .boot files at zero length.
I have boot/image/hard.1. Can I recover these two files using
/boot/image/hard.1? and how can I tell my bootsector to load these
files. Lots of trouble in WTV land.
I was able to do the copy like you suggested, but my bootstrap is messed
up. I
tried hacking around using the QNX6.0 boot strap and it fired up, but the
process don’t seem to want to run. uname -a shows that the 6.0OS is
running not
the 4.25 like I would expect.
Thanks for helping me with my troubles!!!
WTV
“Bill Caroselli (Q-TPS)” wrote:
WAIT A MINUTE!
I was just about to send the message below. However, as is typical of
my I
wasn’t looking at the newsgroup. If your looking for an RTP boot image
then
/boot/images/hard.1 most likely isn’t it. That would be the expected
name
of a QNX4 boot image.
Yes, you should be able to. Just cp /boot/images/hard.1 to .boot of
your
boot partition. Usually:
cp /boot/images/hard.1 /.boot
A crash has left my .altboot and .boot files at zero length.
I have boot/image/hard.1. Can I recover these two files using
/boot/image/hard.1? and how can I tell my bootsector to load these
files. Lots of trouble in WTV land.