“Bill Caroselli (Q-TPS)” <QTPS@earthlink.net> wrote:
I have seen many network cards that didn’t like to work after running
Also, not sure if it’s 100% related, you might try disabling “plug & play OS”
in your BIOS. It probably won’t work anyway if you have it enabled, but just
something else to check…
As they said, do a complete power down/up.
“Chris McKillop” <> email@example.com> > wrote in message
news:aaf15p$du$> firstname.lastname@example.org> …
Fully power off the computer between reboots. That should help.
Eddie Roosenmaallen <> email@example.com> > wrote:
I have a cool new problem with my D-Link DFE530TX card.
Following advice from Andrea Borsic (in a previous post), I switched PCI
slots, and when I booted into QNX, things worked great. However, after
running in W98 for a while, I booted back into QNX, and the card
work. It would appear that W98 is somehow messing with the card’s
It is necessary right now to keep the computer in a dual-boot setup (my
Fiance needs W98 for her graphic design software), so is there a way to
protect the card’s settings from W98, or to reset it when I return to
Chris McKillop <> firstname.lastname@example.org> > “The faster I go, the behinder I get.”
Software Engineer, QSSL – Lewis Carroll –
Robert Krten, PARSE Software Devices +1 613 599 8316.
Realtime Systems Architecture, Books, Video-based and Instructor-led
Training and Consulting at www.parse.com.
Email my initials at parse dot com.