Network Card Supported?

QNX Newsgroups (Archives) qdn.public.qnxrtp.installation
1

Does QNX RTOS v6.1.0 support either of the following 3Com network cards?
3C905-T4 Fast Etherlink XL 10/100
3C900-TPO Fast Etherlink PCI TPO NIC
I have tried and tried … and tried and I haven’t been able to establish a
network connection.

2

If you can post the output from ‘pci -v’ we will be able to tell you.

Previously, Chris Houlberg wrote in qdn.public.qnxrtp.installation:

Does QNX RTOS v6.1.0 support either of the following 3Com network cards?
3C905-T4 Fast Etherlink XL 10/100
3C900-TPO Fast Etherlink PCI TPO NIC
I have tried and tried … and tried and I haven’t been able to establish a
network connection.
\

3

The 905 card is supported, but there have been problems with older 900
cards, so I would suggest that you try the 900 card to see if it works.

Previously, Hugh Brown wrote in qdn.public.qnxrtp.installation:

If you can post the output from ‘pci -v’ we will be able to tell you.

The output from pci -v for each network card is as follows:

For the 3C900-TPO Fast Ether link PCI TPO NIC card:
Class = Network (Ethernet)
Vendor ID = 10b7h, 3Com Corporation
Device ID = 9000h, 3C900-TPO Fast Etherlink PCI TPO NIC
PCI index = 0h
Class Codes = 020000h
Revision ID = 0h
Bus number = 0
Device number = 15
Function num = 0
Status Reg = 200h
Command Reg = 107h
Header type = 0h Single-function
BIST = 18h
Cache Line Size = 0h
PCI IO Address = 500h length 64 enabled
PCI Expansion ROM = ffef0000h length 65536 disabled
Max Lat = 8ns
Min Gnt = 3ns
PCI Int Pin = INT A
Interrupt line = 10

For the C905-T4 Fast Etherlink XL 10/100 card:
Class = Network (Ethernet)
Vendor ID = 10b7h, 3Com Corporation
Device ID = 9051h, 3C900-T4 Fast Etherlink XL 10/100
PCI index = 0h
Class Codes = 020000h
Revision ID = 0h
Bus number = 0
Device number = 15
Function num = 0
Status Reg = 200h
Command Reg = 107h
Header type = 0h Single-function
BIST = 0h Built-in-self-test not supported
Cache Line Size = 0h
PCI IO Address = 500h length 64 enabled
PCI Expansion ROM = ffef0000h length 65536 disabled
Max Lat = 8ns
Min Gnt = 3ns
PCI Int Pin = INT A
Interrupt line = 10

Thanks for responding,

Chris

Previously, Chris Houlberg wrote in qdn.public.qnxrtp.installation:
Does QNX RTOS v6.1.0 support either of the following 3Com network cards?
3C905-T4 Fast Etherlink XL 10/100
3C900-TPO Fast Etherlink PCI TPO NIC
I have tried and tried … and tried and I haven’t been able to establish a
network connection.


\