I have a PC with a Pentium 4 processor and the following IDE disks:
Disk 1 and 2 at the primary IDE bus.
Disk 3 connected via Promise Ultra 133 IDE controller.
I want to install the QNX RTV 6.1.0 on Disk 3, but the installation
program only lists disks 1 and 2 as locations for install.
Is there any method how to get the QNX installed on Disk 3?
Thank you very much for your help!
Might be, there is a plan to support this hardware in RTPEduard.
ed1k at ukr dot net
Thomas Mueller <Thomas.3850@gmx.de> wrote in article <adggne$gl5$1@inn.qnx.com>…
I have a PC with a Pentium 4 processor and the following IDE disks:
Disk 1 and 2 at the primary IDE bus.
Disk 3 connected via Promise Ultra 133 IDE controller.I want to install the QNX RTV 6.1.0 on Disk 3, but the installation
program only lists disks 1 and 2 as locations for install.Is there any method how to get the QNX installed on Disk 3?
Thank you very much for your help!
Thanks for the response.
Now I got the new version 6.2NC and it made the installation on Disk3!!
Great!!
“ed1k” <ed1k@spamerstrap.com> schrieb im Newsbeitrag
news:01c20b99$c96163e0$106fa8c0@ED1K…
Check out supported hardware list. AFAIK Promise Ultra IDE controllers are
not supported, I only
hope this information is out of date >
support this hardware in RTP
6.2?
Best regards,Eduard.
ed1k at ukr dot netThomas Mueller <> Thomas.3850@gmx.de> > wrote in article
adggne$gl5$> 1@inn.qnx.com> >…
I have a PC with a Pentium 4 processor and the following IDE disks:
Disk 1 and 2 at the primary IDE bus.
Disk 3 connected via Promise Ultra 133 IDE controller.I want to install the QNX RTV 6.1.0 on Disk 3, but the installation
program only lists disks 1 and 2 as locations for install.Is there any method how to get the QNX installed on Disk 3?
Thank you very much for your help!