What do I do to setup the RtP network,
on QNX 4.2x I just setup tcpip.1 and netmap,
but where are those files on QNX RtP
and how does it works.
The current setup (default) doesn’t work at all.
I tried to mess with the GUI setup but it didn’t work neither.
I can’t download/install anything and it’s very annoying.
Fred.
Class = Network (Ethernet)
Vendor ID = 10b7h, 3Com Corporation
Device ID = 9050h, 3C905-TX Fast Etherlink XL PCI 10/100
PCI index = 0h
Class Codes = 020000h
Revision ID = 0h
Bus number = 0
Device number = 17
Function num = 0
Status Reg = 200h
Command Reg = 7h
Header type = 0h Single-function
BIST = 0h Build-in-self-test not supported
Latency Timer = 20h
Cache Line Size= 0h
IO Address = 6000h length 64 enabled
Expansion ROM = ffef0000h length 65536 disabled
Max Lat = 8ns
Min Gnt = 3ns
PCI Int Pin = INT A
Interrupt line = 11
What do I do to setup the RtP network,
on QNX 4.2x I just setup tcpip.1 and netmap,
but where are those files on QNX RtP
and how does it works.
I think I replied on another group, but just in case…
Run phlip (as root) under Photon and setup your network.
chris
I try to setup the TCP/IP here and it doesn’t work at all,
we have a Sun OS, Unix, NT/4 network and it worked pretty fine on QNX4,
but with RtP it doesn’t work at all. I can’t ping any where on the
network.
What should I do ??
Is your network card even functional? Can you give me brand and
model # of the ethernet card you are using if it isn’t? Look in
/dev/io-net/
and you should see (at least) en0, ip0 and ip_en entries. Also, you
can run nicinfo and “cat /proc/ipstats” and see what is going on with
the card and the TCP/IP stack. Have you used phlip to configure your
interface?
Well, the network pci card info was given previously.
I didn’t check that, but I used a config in the start button,
I don’t know if it’s phlip.
What do I do to setup the RtP network,
on QNX 4.2x I just setup tcpip.1 and netmap,
but where are those files on QNX RtP
and how does it works.
I think I replied on another group, but just in case…
Run phlip (as root) under Photon and setup your network.
chris
I try to setup the TCP/IP here and it doesn’t work at all,
we have a Sun OS, Unix, NT/4 network and it worked pretty fine on QNX4,
but with RtP it doesn’t work at all. I can’t ping any where on the
network.
What should I do ??
Is your network card even functional? > > Can you give me brand and
model # of the ethernet card you are using if it isn’t? Look in
/dev/io-net/
and you should see (at least) en0, ip0 and ip_en entries. Also, you
can run nicinfo and “cat /proc/ipstats” and see what is going on with
the card and the TCP/IP stack. Have you used phlip to configure your
interface?
Well, the network pci card info was given previously.
I didn’t check that, but I used a config in the start button,
I don’t know if it’s phlip.
Can you give me brand and