PC Card modem not detected

QNX Newsgroups (Archives) qdn.public.qnxrtp.os
1

Hello everyone,

I have a Zoom 2975L Dualmode PC Card Faxmodem inserted in a TI 1420 CardBus
Controller, (which is supported by QNX 6) on my Dell Inspiron 4000.

I can’t seem to get QNX 6.1 to recognize it.
A pin command shows empty slots. For some reason, four slots are listed.
Also, is there a reason why four slots are listed instead of two?

It works fine in RH Linux, and is identified as a “serial or modem.”
I don’t understand why it is not detected, since it is a controller-based
modem.

I would really appreciate it if someone could help me get QNX to detect my
modem.

Thanks,
Jaden Jahner

2

Hi Jaden,



Jaden Jahner <jadenjahner@yahoo.com> wrote:

Hello everyone,

I have a Zoom 2975L Dualmode PC Card Faxmodem inserted in a TI 1420 CardBus
Controller, (which is supported by QNX 6) on my Dell Inspiron 4000.

Can you please post the output of ‘pin cis’

I can’t seem to get QNX 6.1 to recognize it.
A pin command shows empty slots. For some reason, four slots are listed.
Also, is there a reason why four slots are listed instead of two?

This is because we support combo cards. So slot 1 may have a network adapter and
a modem in it. So the two entries for slot 1 would be used. However if the
card is a regular card, then it would only fill one of the entries for slot 1.

Thanks

Erick.