How to exit calib?

QNX Newsgroups (Archives) qdn.public.qnxrtp.photon
1

Hello there,
This is probably a stupid question, but how does one exit the calib
utility. I start calib to calibrate my touchscreen and cycle through
pressing the screen at the four corners and the center. Then a blue box
comes up and states “Press to Complete Calibration.” When I press this,
nothing happens and then when the timer expires the process restarts.

Thanks in advance.

2

Figured out my mistake. Touchdriver was configured for right mouse button.


“Mike” <mseeberger@email.com> wrote in message
news:a9p2ms$ri6$1@inn.qnx.com…

Hello there,
This is probably a stupid question, but how does one exit the calib
utility. I start calib to calibrate my touchscreen and cycle through
pressing the screen at the four corners and the center. Then a blue box
comes up and states “Press to Complete Calibration.” When I press this,
nothing happens and then when the timer expires the process restarts.

Thanks in advance.

3

Ah!

Then you have to touch the screen with a finger on your other hand. ;~}

“Mike” <mseeberger@email.com> wrote in message
news:a9pbcu$4gc$1@inn.qnx.com…

Figured out my mistake. Touchdriver was configured for right mouse
button.


“Mike” <> mseeberger@email.com> > wrote in message
news:a9p2ms$ri6$> 1@inn.qnx.com> …
Hello there,
This is probably a stupid question, but how does one exit the calib
utility. I start calib to calibrate my touchscreen and cycle through
pressing the screen at the four corners and the center. Then a blue box
comes up and states “Press to Complete Calibration.” When I press this,
nothing happens and then when the timer expires the process restarts.

Thanks in advance.
\