No PhAB in QNX 6.1

I have just installed QNX RTP 6.1 and wish to use PhAB. clicking on
“Builder” in the launch menu does nothing though. What is likely to be the
problem?

Regards Col

Does it work if you attempt to run ‘ab’ from a pterm?

“Colin Picking” <cpicking@monduran.com> wrote in message
news:a4ua72$6hq$1@inn.qnx.com

I have just installed QNX RTP 6.1 and wish to use PhAB. clicking on
“Builder” in the launch menu does nothing though. What is likely to be the
problem?

Regards Col

Colin

Did you remember to install it after installing rtp6.1 core, it requires you
to install gcc development tools.

Rod

“Colin Picking” <cpicking@monduran.com> wrote in message
news:a4ua72$6hq$1@inn.qnx.com

I have just installed QNX RTP 6.1 and wish to use PhAB. clicking on
“Builder” in the launch menu does nothing though. What is likely to be the
problem?

Regards Col