Networking ???

QNX Newsgroups (Archives) qdn.public.ddk.network
1

I have a pair of networked PC’s. I have QNX installed on one of them and
would like to configure it so I can access the other PC via the network.

I use the LinkSys Fast Ethernet 10/100 in a Box (uses the LNE100TX). On the
Windows side, there are “no” IP addresses, “no” gateways defined, “no” host
names, etc… Basically, all I had to do was make sure both PC’s were part
of the same workgroup.

What do I need to do so that QNX will have access to the network?

Thanks!

2

Try asking in qdn.public.qnxrtp.newuser as this newsgroup is for those who are
writing network device drivers for QNX.

-Warren " … " Peece


“Dale Frameli” <dframeli@texas.net> wrote in message
news:9k9qds$jr$1@inn.qnx.com…
| I have a pair of networked PC’s. I have QNX installed on one of them and
| would like to configure it so I can access the other PC via the network.
|
| I use the LinkSys Fast Ethernet 10/100 in a Box (uses the LNE100TX). On the
| Windows side, there are “no” IP addresses, “no” gateways defined, “no” host
| names, etc… Basically, all I had to do was make sure both PC’s were part
| of the same workgroup.
|
| What do I need to do so that QNX will have access to the network?
|
| Thanks!