IP Address and gateway address get lost at reboot.

QNX Newsgroups (Archives) qdn.public.ddk.network
1

Hi,
I have QNX RTP installed on DELL Laptop.
Just managed to get the network card that works, Linksys PCMPC200.
As I configure the network from TCP/IP configuration GUI, it can
successfully connect to the LAN and the internet, however, after each
reboot, the configuration is gone and can’t connect to the network
anymore.The setting in /etc/net.cfg is not lost.
Tried both DHCP and Static IP but the result is the same.

Am I missing something? How can you make the network configuration stay?
Please help!

Eri

2

Try to run portmap in rc.local that worked for me.

Jens


“Eri Makimura” <emakimura@aus.telusa.com> wrote in message
news:9ljah1$l0m$1@inn.qnx.com…

Hi,
I have QNX RTP installed on DELL Laptop.
Just managed to get the network card that works, Linksys PCMPC200.
As I configure the network from TCP/IP configuration GUI, it can
successfully connect to the LAN and the internet, however, after each
reboot, the configuration is gone and can’t connect to the network
anymore.The setting in /etc/net.cfg is not lost.
Tried both DHCP and Static IP but the result is the same.

Am I missing something? How can you make the network configuration stay?
Please help!

Eri

3

Hi Eri,

This newsgroup is reserved for questions about the Network Driver
Development Kit. Please keep posts on here on topic.

Thanks

E.


Eri Makimura <emakimura@aus.telusa.com> wrote:

Hi,
I have QNX RTP installed on DELL Laptop.
Just managed to get the network card that works, Linksys PCMPC200.
As I configure the network from TCP/IP configuration GUI, it can
successfully connect to the LAN and the internet, however, after each
reboot, the configuration is gone and can’t connect to the network
anymore.The setting in /etc/net.cfg is not lost.
Tried both DHCP and Static IP but the result is the same.

Am I missing something? How can you make the network configuration stay?
Please help!

Eri