I have some questions about the QNX software package installation.
1)The PC we use is DELL OptiPlex GX1 and the operating system hosts
QNX is Windows 98. How can we set up the network driver in QNX?
When I open the Voyger in QNX, there is Error which says “Invalid Device”.
2)After the QNX 6.20 is stalled, I can’t use command “qcc”. The message is
“/bin/sh not found qcc”. I also try “gcc”,“gdb”. Same situation. Do I need
use
Installer to install the g++ packaage?
There is problem when I use installer. There always is aerror message."…
can’t access…".
3)how to install PhAB (the Photon Application Builder)
?
I have some questions about the QNX software package installation.
1)The PC we use is DELL OptiPlex GX1 and the operating system hosts
QNX is Windows 98. How can we set up the network driver in QNX?
When I open the Voyger in QNX, there is Error which says “Invalid Device”.
Network drivers are auto-scaned and started (for PCI nic cards).
For network settings, looking at “Network Config”.
Do you know what NIC you have ?
2)After the QNX 6.20 is stalled, I can’t use command “qcc”. The message is
“/bin/sh not found qcc”. I also try “gcc”,“gdb”. Same situation. Do I need
use
Installer to install the g++ packaage?
There is problem when I use installer. There always is aerror message."…
can’t access…".
3)how to install PhAB (the Photon Application Builder)
?
Both 2) and 3) seems show you do not have a complete install.
After first boot of the installation, qnxinstaller should
automatically pop out to install “additional packages” from
cdrom.
You can try run qnxinstall (from a “Terminal”), and see
if it will find and install new packages for you (with the
cd in drive of cause)