I have included the “sin” command on an x86 QNX6 installation. For the
most part sin runs fine but when I call “sin interrupts” the message
“sin: warning: interrupt info not implemented” is displayed. What more
needs to be installed?
Regards,
Rick
goldenlint <rpearson@questertangent.com> wrote:
I have included the “sin” command on an x86 QNX6 installation. For the
most part sin runs fine but when I call “sin interrupts” the message
“sin: warning: interrupt info not implemented” is displayed. What more
needs to be installed?
Even on a full system, “sin interrupts” wouldn’t be functional – that
command is not implemented (at this time).
QNX Training Services
http://www.qnx.com/support/training/
Please followup in this newsgroup if you have further questions.
David Gibbs <dagibbs@qnx.com> wrote:
Even on a full system, “sin interrupts” wouldn’t be functional – that
command is not implemented (at this time).
Is there any other method to get this information?
–
| / | __ ) | Karsten.Hoffmann@mbs-software.de MBS-GmbH
| |/| | _ _ \ Phone : +49-2151-7294-38 Karsten Hoffmann
| | | | |) |__) | Fax : +49-2151-7294-50 Roemerstrasse 15
|| ||// Mobile: +49-172-3812373 D-47809 Krefeld
Karsten.Hoffmann@mbs-software.de wrote:
David Gibbs <> dagibbs@qnx.com> > wrote:
Even on a full system, “sin interrupts” wouldn’t be functional – that
command is not implemented (at this time).Is there any other method to get this information?
No. (not at this time)
Ok…I entered a PR a while ago asking for this behaviour. The
PR has moved through a series of states that suggest something like
this has been implemented, but I have no clear idea as to when it
might be available.
QNX Training Services
http://www.qnx.com/support/training/
Please followup in this newsgroup if you have further questions.