QNX 3.0 - PE - PhAB not working...

Hi…

I have run PhAB from Momentics 3.0 - PE running on a windows platform.

I installed cygwin + Xwin in a windowsXP platform, and I messed a little
with the path and so on. Momentics works, but PhAB does not run any more
in windows. It seems that I may have messed something up. I see a dos
shell come up, but it disapear and no PhAB is available.

  1. Where can I see a log of the errors that keep PhAB from running?
  2. since I was messing with the path, which path should I make sure I
    have for PhAB to run properly?
  3. any other things that I should look for?

Thanks.

Regards…

Miguel.

This is a shot in the dark, but you can try to start PhAB from a DOS shell.
If you are lucky some helpful message will appear.

Miguel Simon wrote:

Hi…

I have run PhAB from Momentics 3.0 - PE running on a windows platform.

I installed cygwin + Xwin in a windowsXP platform, and I messed a little
with the path and so on. Momentics works, but PhAB does not run any more
in windows. It seems that I may have messed something up. I see a dos
shell come up, but it disapear and no PhAB is available.

  1. Where can I see a log of the errors that keep PhAB from running?
  2. since I was messing with the path, which path should I make sure I
    have for PhAB to run properly?
  3. any other things that I should look for?

Thanks.

Regards…

Miguel.

Hi Joan…

Your intuition was correct. After messing around with the command line,
I was able to see what was the problem. Just as someone had mentioned
before in another thread, I had two instances of cygwin1.dll. Momentics
was ok with this, but PhAB was not.

Thanks.


Regards…

Miguel.



Joan Baucells wrote:

This is a shot in the dark, but you can try to start PhAB from a DOS shell.
If you are lucky some helpful message will appear.

Miguel Simon wrote:


Hi…

I have run PhAB from Momentics 3.0 - PE running on a windows platform.

I installed cygwin + Xwin in a windowsXP platform, and I messed a little
with the path and so on. Momentics works, but PhAB does not run any more
in windows. It seems that I may have messed something up. I see a dos
shell come up, but it disapear and no PhAB is available.

  1. Where can I see a log of the errors that keep PhAB from running?
  2. since I was messing with the path, which path should I make sure I
    have for PhAB to run properly?
  3. any other things that I should look for?

Thanks.

Regards…

Miguel.