Hello,
We shipped 2 of our PC-based controllers that run on QNX 4 to a customer. We
set each controller as node1. Now, they would like
to communicate with their windows server using SMBfsys. Is it possible to
keep both the QNX controllers as node1 and just change thier IP
addresses in the /etc/hosts file and be able to interface with their windows
server or would we have to set one control as node1 and the other as node2
If we have to change a control to node2, then it would casue some
inconvenience becasue we would have to rename the sysinit files, ph files
etc.
I appreciate your help
Thanks
Shashank
“Shashank” <sbalijepalli@precitech.com> wrote in message
news:dkaj58$6t1$7@inn.qnx.com…
Hello,
We shipped 2 of our PC-based controllers that run on QNX 4 to a customer.
We
set each controller as node1. Now, they would like
to communicate with their windows server using SMBfsys. Is it possible to
keep both the QNX controllers as node1 and just change thier IP
addresses in the /etc/hosts file and be able to interface with their
windows
server or would we have to set one control as node1 and the other as node2
If we have to change a control to node2, then it would casue some
inconvenience becasue we would have to rename the sysinit files, ph files
etc.
It’s not a problem.
Note that if you don’t add the node number of config file the system will
default and look for the file without the extention
I appreciate your help
Thanks
Shashank
If possible i’d like to keep the node numbers on both the controls
identical. All I want to do is to be able to add a line to the “/etc/hosts”
file of control1 that reads
192.168.3.42 node1 xxxx.com
and to control2 that reads
192.168.3.43 node1 xxxx1.com
But in the case of control2, it wont connect to the server whereas in the
first case it does.
Thanks
Shashank
“Mario Charest” postmaster@127.0.0.1 wrote in message
news:dkalar$8mn$1@inn.qnx.com…
“Shashank” <> sbalijepalli@precitech.com> > wrote in message
news:dkaj58$6t1$> 7@inn.qnx.com> …
Hello,
We shipped 2 of our PC-based controllers that run on QNX 4 to a
customer.
We
set each controller as node1. Now, they would like
to communicate with their windows server using SMBfsys. Is it possible
to
keep both the QNX controllers as node1 and just change thier IP
addresses in the /etc/hosts file and be able to interface with their
windows
server or would we have to set one control as node1 and the other as
node2
If we have to change a control to node2, then it would casue some
inconvenience becasue we would have to rename the sysinit files, ph
files
etc.
It’s not a problem.
Note that if you don’t add the node number of config file the system will
default and look for the file without the extention
I appreciate your help
Thanks
Shashank
\