How to set ethernet link speed / mode ?

How to set ethernet link speed / mode in QNX 6.3.2 ?

/after changing switch from 10Mbps to 100Mbps
I’ve got link speed still at 10Mbps;
restarting QNX helps (on 2 computers);

We observed that removing and plugging back in the network cable sometimes helped to re-configure the driver to the new speed.

It largely depends on the driver in use and its options. Also, in SP3 there are allegedly some patches to address this issue. Haven’t tried it myself, though.

Regards,
Albrecht

I wouldn’t expect the driver to switch up without restarting it. Sub standard cables, or broken wire can also cause this problem.