Ethernet driver need

Hi,

I have a computer having onboard “PCIE GbE” LAN card. QNX 6.3 is installed on it, but it cannot create “en0” interface. Which driver should I give as a parameter to the “io-net”?

Thanks,
Mustafa

To little info. Can you post the output of pci -v. Is it 6.3 or 6.3.2?

Hi,

OS version is 6.3.2. Following is the list of the “pci -v” output for network card.
Class = Network (Ethernet)
Vendor ID = 1969h, Unknown
Device ID = 1048h, Unknown Unknown
PCI index = 0h
Class Codes = 020000h
Revision ID = b0h
Bus number = 2
Device number = 0
Function num = 0
Status Reg = 10h
Command Reg = 6h
Header type = 0h Single-function
BIST = 0h Build-in-self-test not supported
Latency Timer = 0h
Cache Line Size= 8h un-cacheable
PCI Mem Address = fe9c0000h 64bit length 262144 enabled
Subsystem Vendor ID = 1043h
Subsystem ID = 8226h
PCI Expansion ROM = fe9a0000h length 131072 disabled
Max Lat = 0ns
Min Gnt = 0ns
PCI Int Pin = INT A
Interrupt line = 10
CPU Interrupt = ah
Capabilities Pointer = 40h
Capability ID = 1h - Power Management
Capabilities = c002h - 0h
Capability ID = 5h - Message Signaled Interrupts
Capabilities = 80h - 0h
Capability ID = 10h - PCI Express
Capabilities = 1h - 287f80h

Regards,
Mustafa

This is from Attansic Technology Crop (Vendor ID 1969) or Atheros. To my knowledge that’s not supported by QNX.