Dual ethernet?

We have a compact PCI board with two ethernet ports. The 4.25 install
CD identified them as tulip based cards. I installed 4.24 but the
driver does not seem to find either card. It reports MAC address of
0000 0000 0000. An IP number seems to be assigned to en1, but networking
doesn’t work. Any help on getting the ports to work is greatly appreciated.


Jiann-Ming Su, js1@microwave.ph.msstate.edu
Criminals, by definition, break the law…

Jiann-Ming Su <js1@microwave.ph.msstate.edu> wrote:

We have a compact PCI board with two ethernet ports. The 4.25 install
CD identified them as tulip based cards. I installed 4.24 but the
driver does not seem to find either card. It reports MAC address of
0000 0000 0000. An IP number seems to be assigned to en1, but networking
doesn’t work. Any help on getting the ports to work is greatly appreciated.

I wouldn’t pay any attention it IP numbers until you have the
network driver running properly. Try running show_pci and then
starting the driver with I/O and interrupt parameters. You will
need to start the driver twice, once for each card.



\

Mitchell Schoenbrun --------- maschoen@pobox.com