Okay, i used the pci -v command and qnx read back:
Class = communication (unknown)
vendor id = 11c1h, AT&T Microelectronics
pci index = 0h
class codes = 078000h
revision id = 1h
bus number = 0
device number = 10
function num = 0
status reg = 290h
command reg = 7h
header type = 0h single-function
BIST = 0h build in self test not supported
Latency timer = 0h
Cache line size = 0h
mem address = e4000000h 32 bit length 256 enabled
IO address = 6200h length 8 enabled
IO address = 6300h length 256 enabled
Cardbus CIS pointer = 40h
Subsystem Vendor ID =1668h
Subsystem ID = 440h
Max Lat = 14ns
Min Gnt = 252ns
PCI int pin = INT A
Interrupt line = 10
capabilities pointer = f8h
capability id = 1h
capabilities = e422h - 0h
Can someone tell me exactly what to type into qnx RTP and where to type
it (reason is i’m an ex-amiga user and don’t really understand manual
pc hardware configuration)
Okay, i used the pci -v command and qnx read back:
Class = communication (unknown)
vendor id = 11c1h, AT&T Microelectronics
pci index = 0h
class codes = 078000h
revision id = 1h
bus number = 0
device number = 10
function num = 0
status reg = 290h
command reg = 7h
header type = 0h single-function
BIST = 0h build in self test not supported
Latency timer = 0h
Cache line size = 0h
mem address = e4000000h 32 bit length 256 enabled
IO address = 6200h length 8 enabled
IO address = 6300h length 256 enabled
Cardbus CIS pointer = 40h
Subsystem Vendor ID =1668h
Subsystem ID = 440h
Max Lat = 14ns
Min Gnt = 252ns
PCI int pin = INT A
Interrupt line = 10
capabilities pointer = f8h
capability id = 1h
capabilities = e422h - 0h
Can someone tell me exactly what to type into qnx RTP and where to type
it (reason is i’m an ex-amiga user and don’t really understand manual
pc hardware configuration)
Only if this is not winmodem:
make sure the devc-ser8250 is not running. (if it is - kill it by e.g. ‘slay
devc-ser8250’ )
try to start serial driver for your pci modem:
devc-ser8250 6200,10 &