Hi…
(My name is Miguel and I am using my wife’s email 
My system: Gateway 933 MHz with 70 GB hardrive and 264 MB RAM.
My problem(s):
I have worked under QNX4, but have no experience under Neutrino. I downloaded
QRTP, and this works fine. However, after two days of tinkering around, it
turns out that I am a bit lost.
-under QNX4 I have multiple machines as different nodes. How do I do this in
QRTP? (i.e. where is the net table where I list the different nodes with the
pertinent hardware information?)
-I know that the sysinit file is no longer available under QRTP, but how do I
customize my init activities? (for example: I have a second hardrive with more
QNX partitions that I want to mount as /home2, I also init the serial ports at
a higher baud rate and specific interrupts, and other like issues…)
-QRTP does not recognize my ethernet card, how do I do this manually? (i.e.
under QNX4 I use nettrap and so on…)
-can I write code in the QRTP machine to execute in a QNX4 machine PC104 based?
-what are the differences between QRTP and Neutrino? I have the impression that
they are the same, but… are they?
On the side…
I have a 3GB partition ready in the 70 GB drive, but I cannot install QNX4 in
this partition because it is toward the end of the drive. Basically FDISK has
problems with just about every thing. I was able to load QRTP in this
partition, but I really want QNX4 instead. Well, any suggestions on how to do
this??
Thank you so much…
Miguel
