I’ve installed from the iso fine but when I first run qnx it attempts to run
it but the series of dots ends with a capital letter ‘C’ and then freezes. No
activity from the hard drive. It just sits there.
I’m using a Tyan S1854, Celeron 566 and a Fujitsu ATA/66 hard drive.
So what you’re telling me is that QNX won’t run at the beginning of my
second hard drive? I’m running W98, W2K, Mandrake Linux and BeOS on my
first drive already.
Is there any way to force QNX to run on my second drive?
I’ve installed from the iso fine but when I first run qnx it
attempts to run
it but the series of dots ends with a capital letter ‘C’ and then
freezes. No
activity from the hard drive. It just sits there.
I’m using a Tyan S1854, Celeron 566 and a Fujitsu ATA/66 hard drive.
Any ideas what is messing up on me? Thanks.
A typical PC problem … your boot image is located at cylinder
1024 …
So what you’re telling me is that QNX won’t run at the beginning of
my
second hard drive? I’m running W98, W2K, Mandrake Linux and BeOS on
my
first drive already.
Is there any way to force QNX to run on my second drive?
No AFAIK … you need at least a small partition for the boot image
in the
address range 1 … 1024
I’ve installed from the iso fine but when I first run qnx it
attempts to run
it but the series of dots ends with a capital letter ‘C’ and then
freezes. No
activity from the hard drive. It just sits there.
I’m using a Tyan S1854, Celeron 566 and a Fujitsu ATA/66 hard
drive.
Any ideas what is messing up on me? Thanks.
A typical PC problem … your boot image is located at cylinder
1024 …