Hi all,
i have a dual celeron motherboard running QNX4.25.I ,then installed the
neutrino by downloading the qnxrtp.tar.F file.Neutrino runs fine and now
i want to get the SMP to run.
I did the following:
mkifs /boot/build/qnxbasesmp.build /tmp/qnxbasesmp.ifs
cp /.boot /.altboot
cp /tmp/qnxbasesmp /.boot.".
But there seems to be no change i.e when i turn on the computer it says
After the POST,
QNX 4 Loader(something like that)
Press Esc for alt OS.
On pressing esc it goes into neutrino .
and on not pressing escape it goes into QNX4.25.
So,is there a way i can get the SMP to work.And is there a command in
SMP to verify whether SMP is working or not(likewe have ping to check
connectivity).
Thank you in advance,
Ankit
“Ankit Pramod Gupta” <ankitgupta3@hotmail.com> wrote in message
news:39E51599.511BA610@hotmail.com…
Hi all,
i have a dual celeron motherboard running QNX4.25.I ,then installed the
neutrino by downloading the qnxrtp.tar.F file.Neutrino runs fine and now
i want to get the SMP to run.
BP6, that’s use successfully by some people.
I did the following:
mkifs /boot/build/qnxbasesmp.build /tmp/qnxbasesmp.ifs
cp /.boot /.altboot
cp /tmp/qnxbasesmp /.boot.".
I assume the .ifs missing in the command is a typo?
But there seems to be no change i.e when i turn on the computer it says
After the POST,
QNX 4 Loader(something like that)
Press Esc for alt OS.
On pressing esc it goes into neutrino .
and on not pressing escape it goes into QNX4.25.
Check the data of the .boot file to see if you did the operation properly.
So,is there a way i can get the SMP to work.And is there a command in
SMP to verify whether SMP is working or not(likewe have ping to check
connectivity).
In the shelf you should see two CPU indicators.
Also at startup (just after “pressing esc…” ) you should
see the description for 2 processors.
Thank you in advance,
Ankit