Graphics problems, and a Question.

QNX Newsgroups (Archives) comp.os.qnx
1

Graphics Problem: I installed QNX on my computer and I ended up getting
16 colors on QNX. I tried using the VESA drivers and its saying “SVGA
device not detected.” I just installed a new mother board, with an
Intel Pentium III processor 866 Mhz this christmas. What can I do about
it?


Sent via Deja.com
http://www.deja.com/

2

karma_suture@my-deja.com wrote:

Graphics Problem: I installed QNX on my computer and I ended up getting
16 colors on QNX. I tried using the VESA drivers and its saying “SVGA
device not detected.” I just installed a new mother board, with an
Intel Pentium III processor 866 Mhz this christmas. What can I do about
it?

What version of QNX did you install? That sort of information is very
helpful.

-David

QNX Training Services
dagibbs@qnx.com

3

Does the graphics configuration utility give you any 16,24, or 32 bit
direct modes? If not, either you aren’t using the best driver, or
maybe there is not support on this card.


Previously, karma_suture@my-deja.com wrote in comp.os.qnx:

Graphics Problem: I installed QNX on my computer and I ended up getting
16 colors on QNX. I tried using the VESA drivers and its saying “SVGA
device not detected.” I just installed a new mother board, with an
Intel Pentium III processor 866 Mhz this christmas. What can I do about
it?


Sent via Deja.com
http://www.deja.com/

–
Mitchell Schoenbrun --------- maschoen@pobox.com