After installation of QNX 6.2.1 NC there is no network available.
I slayed and restarted io-net -ptcpip
The following error message is displayed:
unable to load dll npm-txpip: Library cannot be found
Anybody knows a solution?
TIA
Werner
ps: I attached the output of pci -v
You have to do it all as root. And it is tcpip not txpip.
Yes, I did it as root
and I entered “io-net -ptcpip”
but the error message was
“unable to load dll npm-txpip: Library cannot be found”
Werner
Hello,
You need to run io-net with "-d " option also.
I think, first you need to know which driver to use for this.
/etc/system/enum/net file may give you supported drivers for QNX.
Thank you.
But I didn’t find out, which driver to use.
For that reason I attached the output
of “pci -v” to my first post.
I was hoping, anybody could point me to the driver to use
or give me the information, if my network card is supported or not.
Werner
Here again the relevant part of “pci -v”
Class = Network (Ethernet)
Vendor ID = 1282h, Davicom Semiconductor Inc.
Device ID = 9102h, DM9102/A/AF GFast Ethernet Adapter
PCI index = 0h
Class Codes = 020000h
Revision ID = 31h
Bus number = 0
Device number = 11
Function num = 0
Status Reg = 210h
Command Reg = 7h
Header type = 0h Single-function
BIST = 0h Build-in-self-test not supported
Latency Timer = 20h
Cache Line Size= 0h
PCI IO Address = b800h length 256 enabled
PCI Mem Address = e0800000h 32bit length 256 enabled
Subsystem Vendor ID = 3030h
Subsystem ID = 5032h
Max Lat = 40ns
Min Gnt = 20ns
PCI Int Pin = INT A
Interrupt line = 15
Capabilities Pointer = 50h
Capability ID = 1h
Capabilities = c031h - 100h
Does anybody know if this card is supported
and which driver to use?
TIA
Werner
I still didn’t get a response.
Does anybody know if QNX 6.2.1 supports the
CNet Pro200 PCI Fast Ethernet Adapter?
Werner Schweizer