I am trying to install the QNX Momentics 6.2.1 to a PC/104+ system from the
CD-Rom. But each time the installation process stops at displaying “Detected
EIDE. Scanning for devices”. When choosing “F6 Be verbose” as the boot
option, installation stops at displaying “Trying to detect SCSI aha2” and
“Trying to detect SCSI aha4”.
The processor of the system is a 300MHz National Semiconductor Geode GX1 MMX
enhanced microprocessor with the math coprocessor; with six 8237 compatible
DMA channels. 128MB memory. 2GB harddisk. QNX4.25 is currently installed.
Have no clue of what to do, any instructions are highly appreciated.
Thanks,
JianJ. Chang
I had some troubles to do that in a TWT pc-104 board.
It was just because I had wrong BIOS configuration,
Isn´t the case ?
“Jeff Chang” <jianjunc@cae.wisc.edu> escreveu na mensagem
news:b7cem2$duq$1@inn.qnx.com…
I am trying to install the QNX Momentics 6.2.1 to a PC/104+ system from
the
CD-Rom. But each time the installation process stops at displaying
“Detected
EIDE. Scanning for devices”. When choosing “F6 Be verbose” as the boot
option, installation stops at displaying “Trying to detect SCSI aha2” and
“Trying to detect SCSI aha4”.
The processor of the system is a 300MHz National Semiconductor Geode GX1
MMX
enhanced microprocessor with the math coprocessor; with six 8237
compatible
DMA channels. 128MB memory. 2GB harddisk. QNX4.25 is currently installed.
Have no clue of what to do, any instructions are highly appreciated.
Thanks,
JianJ. Chang