“Ron Cococcia” <firstname.lastname@example.org> wrote in message
The setup we have is a 300MB QNX partition, and the rest is taken by
Using Ghost, we can copy the drive between different geometries easily and
it works pretty well, since Ghost automatically resizes FAT32 to whatever
Yeah but it doesn’t know about the QNX partition…
I’m about to go in by hand and dinit the partition and copy the
contents over manually to see if that will work.
“Mario Charest” <> email@example.com> > wrote in message
news:a7od0g$3n5$> firstname.lastname@example.org> …
“Ron Cococcia” <> email@example.com> > wrote in message
news:a7oah9$2d3$> firstname.lastname@example.org> …
As a test I was asked to do with the setup my product uses, I copied
drive image onto a 1GB WD Caviar drive. When I try to boot it, I get
“…” and it stops (normally I get 10).
Drive image? That usually not a good idea to copy drive image onto HD
I haven’t done too much, and it’s not really all that important that I
it working, but I was curious as to what might need to be modified in
boot image to get it to boot. I have looked at the different boot
and tried a couple different boot images, but none seemed to do
different. Any ideas are appreciated.