I installed QNX6.10 on my Toshiba 2800 notebook,it seems that my audio card
(YAMAHA DS1)has been installed correctly,I can find the pahtname space of
/dev/snd,I can use phplay to load the .mp3 and .wav file but after the
loading,it will be locked untill I slay it,can somebody help?thanx.
best regards.
ChaoLi
I have posted my problem here and get no response,I guess that’s because
there is not enough information to make the examination with.so I put the
informations I can of my system here,I hope the QNX or somebody can help me.
the pci -v output like this:
Class = Multimedia (Audio)
Vendor ID = 1073h, Yamaha Corporation
Device ID = 12h, YMF754B DS-1S Audio
PCI index = 0h
Class Codes = 040100h
Revision ID = 0h
Bus number = 0
Device number = 12
Function num = 0
Status Reg = 210h
Command Reg = 7h
I/O space access enabled
Memory space access enabled
Bus Master enabled
Special Cycle operations ignored
Memory Write and Invalidate disabled
Palette Snooping disabled
Parity Checking disabled
Data/Address stepping disabled
SERR# driver disabled
Fast back-to-back transactions to different agents disabled
Header type = 0h Single-function
BIST = 0h Build-in-self-test not supported
Latency Timer = 20h
Cache Line Size= 0h
PCI Mem Address = efdf0000h 32bit length 32768 enabled
PCI IO Address = fec0h length 64 enabled
PCI IO Address = febch length 4 enabled
Subsystem Vendor ID = 1179h
Subsystem ID = 1h
Max Lat = 25ns
Min Gnt = 5ns
PCI Int Pin = INT A
Interrupt line = 11
Capabilities Pointer = 50h
Capability ID = 1h
Capabilities = 401h - 0h
Device Dependent Registers:
0x40: 80 bf 00 18 79 11 01 00 00 00 05 ff 00 00 ff 1f
0x50: 01 00 01 04 00 00 00 00 00 00 00 00 00 00 00 00
0x60: 88 03 20 02 30 03 01 02 00 00 00 00 00 00 00 00
0x70: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
0x80: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
0x90: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
0xA0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
0xB0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
0xC0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
0xD0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
0xE0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
0xF0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
I slay the io-audio and run it again:
io-audio -d ymfds1 &
and then the /dev/snd has the components of:
controlC0
mixerC0D0
pcmC0D0c
pcmC0D0p
pcmPreferredc
pcmPreferredp
but the photon player still be locked after it loading the media file
IIs that information enough?Can someone help me?
by the way I can not find the rc.local file ,It’s siad that it should be in
the /etc/rc.d,but I cann’t find it there,I use QNX 6.1
Thanks.
Best regards.
ChaoLi
ChaoLi <qnx_basic@sohu.com> wrote:
I have posted my problem here and get no response,I guess that’s because
there is not enough information to make the examination with.so I put the
informations I can of my system here,I hope the QNX or somebody can help me.the pci -v output like this:
Class = Multimedia (Audio)
Vendor ID = 1073h, Yamaha Corporation
Device ID = 12h, YMF754B DS-1S Audio
PCI index = 0h
Class Codes = 040100h
Revision ID = 0h
Bus number = 0
Device number = 12
Function num = 0
Status Reg = 210h
Command Reg = 7h
I/O space access enabled
Memory space access enabled
Bus Master enabled
Special Cycle operations ignored
Memory Write and Invalidate disabled
Palette Snooping disabled
Parity Checking disabled
Data/Address stepping disabled
SERR# driver disabled
Fast back-to-back transactions to different agents disabled
Header type = 0h Single-function
BIST = 0h Build-in-self-test not supported
Latency Timer = 20h
Cache Line Size= 0h
PCI Mem Address = efdf0000h 32bit length 32768 enabled
PCI IO Address = fec0h length 64 enabled
PCI IO Address = febch length 4 enabled
Subsystem Vendor ID = 1179h
Subsystem ID = 1h
Max Lat = 25ns
Min Gnt = 5ns
PCI Int Pin = INT A
Interrupt line = 11
Capabilities Pointer = 50h
Capability ID = 1h
Capabilities = 401h - 0h
Device Dependent Registers:
0x40: 80 bf 00 18 79 11 01 00 00 00 05 ff 00 00 ff 1f
0x50: 01 00 01 04 00 00 00 00 00 00 00 00 00 00 00 00
0x60: 88 03 20 02 30 03 01 02 00 00 00 00 00 00 00 00
0x70: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
0x80: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
0x90: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
0xA0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
0xB0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
0xC0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
0xD0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
0xE0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
0xF0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00I slay the io-audio and run it again:
io-audio -d ymfds1 &
and then the /dev/snd has the components of:controlC0
mixerC0D0
pcmC0D0c
pcmC0D0p
pcmPreferredc
pcmPreferredpbut the photon player still be locked after it loading the media file
IIs that information enough?Can someone help me?
by the way I can not find the rc.local file ,It’s siad that it should be in
the /etc/rc.d,but I cann’t find it there,I use QNX 6.1
The rc.local file doesn’t exist until you create it. Just create the file
with an editor and add the commands you want executed as start-up. Also,
don’t forget to use chmod to make the file executable.
Barry
Thanks.
Best regards.
ChaoLi
The rc.local file doesn’t exist until you create it. Just create the file
with an editor and add the commands you want executed as start-up. Also,
don’t forget to use chmod to make the file executable.Barry
Thanx,but how about the Phplay Locking?Shall I ask the toshiba for help-
ChaoLi