Could anyone tell me why the “nettrap” commando is not found when I write
it? I can’t find any documentation in the help tool about nettrap…
Thanks a lot!
Thanks, Joe!
Just one more question… I want to know if the network card I’m trying to
configure is recognized by the system. How can I do it?
Thanks again!
Cesar
“QNX News” <hw@qnx.com> escreveu na mensagem
news:ae7dj1$1q9$1@inn.qnx.com…
Hi Cesar,
nettrap is not used in QNX 6.1.
The system enumerators will detect you network card and start up the
appropriate driver.Regards,
Joe
“Cesar Ossamu Ida” <> root@qnx.com> > wrote in message
news:> Pine.NTO.4.21.0206101636010.1232937-100000@minardi.inf.ufrgs.br> …
Could anyone tell me why the “nettrap” commando is not found when I
write
it? I can’t find any documentation in the help tool about nettrap…Thanks a lot!
Hi Cesar,
nettrap is not used in QNX 6.1.
The system enumerators will detect you network card and start up the
appropriate driver.
Regards,
Joe
“Cesar Ossamu Ida” <root@qnx.com> wrote in message
news:Pine.NTO.4.21.0206101636010.1232937-100000@minardi.inf.ufrgs.br…
Could anyone tell me why the “nettrap” commando is not found when I write
it? I can’t find any documentation in the help tool about nettrap…Thanks a lot!
Hi Cesar,
You can do two things:
-
Check to see if a driver lib was mounted into io-net for you NIC.
To do this do a pidin | mem and check if there is a devn* entry
under io-net
If there is a devn* lib under io-net then the system reconized
your card and started the driver…you can use phlip to configure it. -
Check to see if the system enumerators have an entry for your card.
To do this do a pci -vvv to get your NIC’s device ID (you will have
to sift through some output)
Then goto /etc/system/enum/devices and look in the net file to see
if your NICs device ID is referenced.
Regards,
Joe
“Cesar” <cesarida@inf.ufrgs.br> wrote in message
news:ae7rdu$c0d$1@inn.qnx.com…
Thanks, Joe!
Just one more question… I want to know if the network card I’m trying to
configure is recognized by the system. How can I do it?Thanks again!
Cesar“QNX News” <> hw@qnx.com> > escreveu na mensagem
news:ae7dj1$1q9$> 1@inn.qnx.com> …
Hi Cesar,nettrap is not used in QNX 6.1.
The system enumerators will detect you network card and start up the
appropriate driver.Regards,
Joe
“Cesar Ossamu Ida” <> root@qnx.com> > wrote in message
news:> Pine.NTO.4.21.0206101636010.1232937-100000@minardi.inf.ufrgs.br> …
Could anyone tell me why the “nettrap” commando is not found when I
write
it? I can’t find any documentation in the help tool about nettrap…Thanks a lot!
\