Has anyone gotten QNX to work on this board? I am considering buying one refurbished from Jumptec.
Cheers.
Chris
Has anyone gotten QNX to work on this board? I am considering buying one refurbished from Jumptec.
Cheers.
Chris
Hello Chris,
The board should work being a 586DX-133 MHz. As far as the other
hardware on the board goes, you’ll have to find out what’s on the board
and look it up on our supported hardware page.
Regards,
Dave B.
Chris Turkel wrote:
Has anyone gotten QNX to work on this board? I am considering buying one refurbished from Jumptec.
Cheers.
Chris
Hello Chris
The MOPSlcd4 is running very well. You have to use the -h option
during startup. This option disable CPU halting in idle thread.
Some CPU and supporting chipsets can look up if the CPU halts
when idle. Try to to use the following in boot image file:
[virtual=x86,bios +compress] boot = {
startup-bios -N name
procnto -h
}
BitCtrl Systems GmbH
E-Mail: info@bitctrl.de
Internet: www.bitctrl.de, www.bitctrl.com
Tel: +49 341-490670
Fax: +49 341-4906715
“Chris Turkel” <zizban@adelphia.net> schrieb im Newsbeitrag
news:a325k5$2qr$1@inn.qnx.com…
Has anyone gotten QNX to work on this board? I am considering buying one
refurbished from Jumptec.Cheers.
Chris
Thanks! Just in time! I just the kit today and it’s sitting right here!
Dr. G. Geigemüller wrote:
Subject: Re: MOPSlcd4
From: “Dr. G. Geigemüller” <> Gunter.Geigemueller@bitctrl.de
Date: Thu, 31 Jan 2002 17:46:08 +0100Hello Chris
The MOPSlcd4 is running very well. You have to use the -h option
during startup. This option disable CPU halting in idle thread.
Some CPU and supporting chipsets can look up if the CPU halts
when idle. Try to to use the following in boot image file:[virtual=x86,bios +compress] boot = {
startup-bios -N name
procnto -h
}Regards
Dr. Gunter GeigemüllerBitCtrl Systems GmbH
E-Mail: > info@bitctrl.de
Internet: > www.bitctrl.de> , > www.bitctrl.com
Tel: +49 341-490670
Fax: +49 341-4906715
“Chris Turkel” <> zizban@adelphia.net> > schrieb im Newsbeitrag
news:a325k5$2qr$> 1@inn.qnx.com> …
Has anyone gotten QNX to work on this board? I am considering buying one
refurbished from Jumptec.Cheers.
Chris