It is my understanding that QNX RTOS 6.1 only supports up to P3. It that
correct?
If so, does anyone know when they plan to support P4?
Thanks in advance.
Billy Gote
“Billy Gote” <odonovan@montanadsl.net> wrote in message
news:a3f2ec$ped$1@inn.qnx.com…
It is my understanding that QNX RTOS 6.1 only supports up to P3. It that
correct?
It has been reported to run on P4 system
If so, does anyone know when they plan to support P4?
Thanks in advance.
Billy Gote
I think the only issue is that the compiled programs can only by optinized
for a P3. I.E. It won’t try to use any P4 instructions.
–
Bill Caroselli – 1(626) 824-7983
Q-TPS Consulting
QTPS@EarthLink.net
“Mario Charest” <goto@nothingness.com> wrote in message
news:a3f9i8$lt$1@inn.qnx.com…
“Billy Gote” <> odonovan@montanadsl.net> > wrote in message
news:a3f2ec$ped$> 1@inn.qnx.com> …
It is my understanding that QNX RTOS 6.1 only supports up to P3. It that
correct?
It has been reported to run on P4 systemIf so, does anyone know when they plan to support P4?
Thanks in advance.
Billy Gote
\
Thanks-
Trying to boot from QNX 6.1 CD and get to boot options, but locks up
regardless of options chosen.
Have boot partition and second drive to install on, but don’t seem to get
that far.
Any thoughts would be appreciated.
Billy
“Bill Caroselli” <qtps@earthlink.net> wrote in message
news:a3havr$cob$1@inn.qnx.com…
I think the only issue is that the compiled programs can only by optinized
for a P3. I.E. It won’t try to use any P4 instructions.–
Bill Caroselli – 1(626) 824-7983
Q-TPS Consulting
QTPS@EarthLink.net
“Mario Charest” <> goto@nothingness.com> > wrote in message
news:a3f9i8$lt$> 1@inn.qnx.com> …“Billy Gote” <> odonovan@montanadsl.net> > wrote in message
news:a3f2ec$ped$> 1@inn.qnx.com> …
It is my understanding that QNX RTOS 6.1 only supports up to P3. It
that
correct?
It has been reported to run on P4 systemIf so, does anyone know when they plan to support P4?
Thanks in advance.
Billy Gote
\