SCSI adapter AIC7880

Working in QNX6.0, found not to be working in 6.1
It is equivalent of Adaptec 2940W.

What do you mean when you say it’s not working? Are there any error
messages returned when you start the driver? If not, try starting the
driver using the -vvv option for verbosity.

Regards,
Dave B.



Jiri Kristek wrote:

Working in QNX6.0, found not to be working in 6.1
It is equivalent of Adaptec 2940W.

Sorry I did not mention AIC7880 is based on motherboard, type IWILL PIILS.
Works with QNX4, QNX6.0
Results for QNX6.1:

\

devb-aha8 cam verbose

scsi_interpret_sense: path=0, target=0, lun=0, cam_status=79,

scsi_status=0
scsi_interpret_sense: path=0, target=1, lun=0, cam_status=79, scsi_status=0
scsi_interpret_sense: path=0, target=2, lun=0, cam_status=79, scsi_status=0
scsi_interpret_sense: path=0, target=4, lun=0, cam_status=79, scsi_status=0


\

pci

PCI version = 2.10

Class = Mass Storage (IDE)
Vendor ID = 8086h, Intel Corporation
Device ID = 7111h, 82371AB/EB PIIX4 IDE Controller
PCI index = 0h
PCI IO Address = f000h enabled
PCI Int Pin = NC
Interrupt line = 0

Class = Network (Ethernet)
Vendor ID = 1022h, Advanced Micro Devices
Device ID = 2000h, 79C970 Ethernet Ctrlr
PCI index = 0h
PCI IO Address = 6800h enabled
PCI Int Pin = INT A
Interrupt line = 10

Class = Multimedia (Audio)
Vendor ID = 1993h, Unknown
Device ID = 4013h, Unknown Unknown
PCI index = 0h
PCI Mem Address = e4000000h enabled
PCI Int Pin = INT A
Interrupt line = 9

Class = Mass Storage (SCSI)
Vendor ID = 9004h, Adaptec
Device ID = 8078h, AIC-7880 Ultra Wide SCSI
PCI index = 0h
PCI IO Address = 6400h enabled
PCI Mem Address = e4001000h enabled
PCI Int Pin = INT A
Interrupt line = 9

Class = Display (VGA)
Vendor ID = 1002h, ATI Technologies
Device ID = 4742h, Rage 3D Pro AGP 2x
PCI index = 0h
PCI Mem Address = a8000000h enabled
PCI IO Address = e000h disabled
PCI Mem Address = d8000000h enabled
PCI Expansion ROM = d8020000h disabled
PCI Int Pin = NC
Interrupt line = no connection





Hardware Support Account <hw@qnx.com> píse v diskusním
pøíspìvku:3C682873.9070406@qnx.com

What do you mean when you say it’s not working? Are there any error
messages returned when you start the driver? If not, try starting the
driver using the -vvv option for verbosity.

Regards,
Dave B.



Jiri Kristek wrote:

Working in QNX6.0, found not to be working in 6.1
It is equivalent of Adaptec 2940W.
\