I’m looking for some PC104 or SBC for embedded data acquisition purpose.
They should have the following features.
Lower power design, more than 8 A/D inputs and at lease two serial ports.
I found the Prometheus from Diamond Systems does fulfill my requirement.
However, I’m not sure whether this board work well with QNX6.1. Is there any
one who experience with this board?
Thanks in advance for any advice.
Derek
We use this card under QNX 4.25. I’d be suprised if it didn’t “just work”
under 6.1.
Larry
“Derek Chan” <kawachan@hko.gov.hk> wrote in message
news:a7n7ra$6nh$1@inn.qnx.com…
I’m looking for some PC104 or SBC for embedded data acquisition purpose.
They should have the following features.
Lower power design, more than 8 A/D inputs and at lease two serial ports.
I found the Prometheus from Diamond Systems does fulfill my requirement.
However, I’m not sure whether this board work well with QNX6.1. Is there
any
one who experience with this board?
Thanks in advance for any advice.Derek
\
Thank you, I’m glad to know someone has use this card before.
As I have no experience in embedding QNX. It’s quite difficult in selecting
a suitable hardware at the very beginning. Prometheus and its peripherals
seems meet my initial hardware requirements. Although Diamond Systems has
stated that they are about to start up development work for drivers packages
which support QNX , they are not partner of QNX. I still can’t get enough
confidence in choosing a hardware until someone told me their stories!
Thanks again.
Derek
Lawrence R. Sweet <lrsweet@cogeco.ca> wrote in message
news:a7o843$nh$1@inn.qnx.com…
We use this card under QNX 4.25. I’d be suprised if it didn’t “just work”
under 6.1.Larry
“Derek Chan” <> kawachan@hko.gov.hk> > wrote in message
news:a7n7ra$6nh$> 1@inn.qnx.com> …
I’m looking for some PC104 or SBC for embedded data acquisition purpose.
They should have the following features.
Lower power design, more than 8 A/D inputs and at lease two serial
ports.
I found the Prometheus from Diamond Systems does fulfill my requirement.
However, I’m not sure whether this board work well with QNX6.1. Is there
any
one who experience with this board?
Thanks in advance for any advice.Derek
\