Can not see mousepointer from ph

QNX Newsgroups (Archives) qdn.public.qnxrtp.installation
1

I have installed the lastest qnx from getqnx.com and when I run the ph
program I do not see any mouse pointer from the higher resolution. I
get the test screen where I see my mouse, but when I switch to the
larger mode, the mouse pointer goes away. I can tell that it is there,
by right clicking and the menu pops up where the mouse should be.

I am running on an older Micron Millenium 200 MHZ.

When I pop the IDE disk into my newer dell computer the mouse pointer
acts just fine.

Any suggestions. I checked that the phcursor file was in the correct
place.

TIA

WTV.

2

Hi

Could you please download the graphics information grabbing
script from:

http://www.geocities.com/erickmuis/files/hardware_scripts/nto/

DO NOT START PHOTON.

Then extract the scripts and login as the root user. Once you
are logged in as the root user, please run the script:

…/grafxscript.rtp

Once the script has run, please send us the output.

Thanks

Erick.


WTV <w_valdez@nospam.pnl.gov> wrote:

I have installed the lastest qnx from getqnx.com and when I run the ph
program I do not see any mouse pointer from the higher resolution. I
get the test screen where I see my mouse, but when I switch to the
larger mode, the mouse pointer goes away. I can tell that it is there,
by right clicking and the menu pops up where the mouse should be.

I am running on an older Micron Millenium 200 MHZ.

When I pop the IDE disk into my newer dell computer the mouse pointer
acts just fine.

Any suggestions. I checked that the phcursor file was in the correct
place.

TIA

WTV.

3

Responded via e-mail (needed an updated driver that fixed
this issue).

Erick.


Hardware Support Account <hw@qnx.com> wrote:

Hi

Could you please download the graphics information grabbing
script from:

http://www.geocities.com/erickmuis/files/hardware_scripts/nto/

DO NOT START PHOTON.

Then extract the scripts and login as the root user. Once you
are logged in as the root user, please run the script:

./grafxscript.rtp

Once the script has run, please send us the output.

Thanks

Erick.



WTV <> w_valdez@nospam.pnl.gov> > wrote:
I have installed the lastest qnx from getqnx.com and when I run the ph
program I do not see any mouse pointer from the higher resolution. I
get the test screen where I see my mouse, but when I switch to the
larger mode, the mouse pointer goes away. I can tell that it is there,
by right clicking and the menu pops up where the mouse should be.

I am running on an older Micron Millenium 200 MHZ.

When I pop the IDE disk into my newer dell computer the mouse pointer
acts just fine.

Any suggestions. I checked that the phcursor file was in the correct
place.

TIA

WTV.