I’m trying to update a self hosted 6.2.0 installation on
a 166MHz P1 to 6.2.1.
After running once (to install the new installer & updater)
qnxinstall refuses to run properly.
Instead it’s running READY at 10
I will leave it overnight to see if it’s just CPU cycles.
I’ve disabled the network, so it’s running standalone.
Any ideas?
Hi.
What happened over night? If your still having problems could please run
qnxinstall -f verbosity=3 and send me the /etc/system/package/session.log.
Thanks
Andrew
<acellarius@yahoo.com> wrote in message news:1103_1046115756@192.168.0.5…
I’m trying to update a self hosted 6.2.0 installation on
a 166MHz P1 to 6.2.1.
After running once (to install the new installer & updater)
qnxinstall refuses to run properly.
Instead it’s running READY at 10
I will leave it overnight to see if it’s just CPU cycles.
I’ve disabled the network, so it’s running standalone.
Any ideas?
It was still running.
sloginfo showed some complaints about scsi sense (this
is an install to IDE).
I should get access to the machine again soon and
will post that info and the session.log file.
Thanks!
On Tue, 25 Feb 2003 14:41:54 -0500, “Andrew Scheel” <ascheel@qnx.com> wrote:
Hi.
What happened over night? If your still having problems could please run
qnxinstall -f verbosity=3 and send me the /etc/system/package/session.log.
Thanks
Andrewacellarius@yahoo.com> > wrote in message news:1103_1046115756@192.168.0.5…
I’m trying to update a self hosted 6.2.0 installation on
a 166MHz P1 to 6.2.1.
After running once (to install the new installer & updater)
qnxinstall refuses to run properly.
Instead it’s running READY at 10
I will leave it overnight to see if it’s just CPU cycles.
I’ve disabled the network, so it’s running standalone.
Any ideas?
\