We are still in serious need of a low cost RAID 1 solution for
Neutrino. We are about to abandon Neutrino if none exhists. We have
found 4 other possible solutions requiring a re-write of our code but
viable.
Let me know if you find any RAID 1 controllers for Neutrino. We are
considering the operating sysetm for a project but will probably end
up using Linux.
On Tue, 20 Feb 2001 08:36:18 -0600, Oswaldo <os@bout.net> wrote:
We are still in serious need of a low cost RAID 1 solution for
Neutrino. We are about to abandon Neutrino if none exhists. We have
found 4 other possible solutions requiring a re-write of our code but
viable.
“Oswaldo” <os@bout.net> wrote in message
news:dqv49tor58cola793gab6uofdvet4uenun@4ax.com…
We are still in serious need of a low cost RAID 1 solution for
Neutrino. We are about to abandon Neutrino if none exhists. We have
found 4 other possible solutions requiring a re-write of our code but
viable.
I have been using their Dupli-Disk I for a couple years on my QNX4 system
without any
problems. I haven’t tried it with RTP yet but since the hardware is OS
independent there
SHOULDN’T be any problems…
Good luck.
~ Lee R. Copp
~ Project Engineer (EE/ME)
~ Michigan Scientific Corp.
~ 321 East Huron St.
~ Milford, MI 48381
~ 248-685-3939 x109 (V), 248-684-5406 (Fx)
~ http://www.michiganscientific.com
~ mailto:<Lee.R.Copp@MichiganScientific.com>
On Tue, 20 Feb 2001 14:30:03 -0500, “Lee R. Copp”
<Lee.R.Copp@MichiganScientific.com> wrote:
“Oswaldo” <> os@bout.net> > wrote in message
news:> dqv49tor58cola793gab6uofdvet4uenun@4ax.com> …
We are still in serious need of a low cost RAID 1 solution for
Neutrino. We are about to abandon Neutrino if none exhists. We have
found 4 other possible solutions requiring a re-write of our code but
viable.I have been using their Dupli-Disk I for a couple years on my QNX4 system
without any
problems. I haven’t tried it with RTP yet but since the hardware is OS
independent there
SHOULDN’T be any problems…>Good luck.
~ Lee R. Copp ~ Project Engineer (EE/ME) ~ Michigan Scientific Corp. ~ 321 East Huron St. ~ Milford, MI 48381 ~ 248-685-3939 x109 (V), 248-684-5406 (Fx) ~ > http://www.michiganscientific.com ~ mailto:> <Lee.R.Copp@MichiganScientific.com>
We tried Dupli-Disk but could not boot off of a survivor, deal with
techs mismatching pairs and it takes forever to build a pair. Also, I
dosen’t give us two independant pairs of drives. You must use master
slave so that if you lose one disk you will lose 2.
We also need to look at a SCIS solution that is not too expensive.